GL1800Riders Forums banner


  1. Fuse #12 St.Stop, 10 amp, blows

    GL1800 Tech Board
    2012 GW w/ Navi and 2018 Roadsmith Trike conversion. Fuse #12 St.Stop, 10 amp, blows Here's the problem. I start the bike, put it in first gear, it goes about 100 yards and then dies. At that point, I have all my lights, headlight, turn signals, brake lights, reverse, but I have no ignition...
  2. Escapade Trailers

    GL1800 Tech Board
    I'm looking at getting an Escapade Excel trailer to match my 2017 'wing. I have a Bushtec hitch installed and Kuryakyn wiring. Does anyone else have a similar setup? If so, how did you secure the bike-end connector? I don't want it visible when not hooked up, but want it to be secure and...
  3. GL1800 Wiring Harness splices.. Engine Coolant Temp Sensor - Open Loop to ECM

    GL1800 Tech Board
    Has anyone had to open up their Main Harness to remedy an open circuit in the Engine Coolant Temp Sensor path to the ECM ? I was wondering where the best place to start to open my 04 Wiring Harness to fix the Yellow/Blue and Green/Red wiring that appears to have gone open during engine install...
  4. WIRING change in 2010???

    GL1800 Tech Board
    I installed Wig-Wag brake modulator on my 06 on trunk lights only - lowers stayed on...worked perfectly for 3 years;) until a deer encounter:o4:. Insurance did right by me:lol:, and I am now modifying my new 2010...including same Wig-wag modulator. I installed by splicing into green wire...
  5. Main Wiring Harness Question

    GL1800 Tech Board
    It looks like due to some issues I am going to have to replace the main wiring harness on my 02 1800 Non ABS. I found one on eBay and asked the seller if it was with or without ABS and he did not respond to me till after the sale was over. But due to price, I went ahead and bought it as the...
  6. Aux plug Wiring and GPS

    Electronic motorcycle devices
    I have a Zumo 660. I am trying to hook up the wiring to the aux plug behind the left hand storage bin. The aux plug has 4 leads, what colours are power and ground? Does anything have to be done to provide power to the plug? I checked with a test light and couldn"t get anything...
  7. Intercom whine harness install tip for '01s

    GL1800 Tech Board
    Hello, all. Yesterday I installed the "intercom alternator whine reducer" harness (officially called "ACG Line Noise Sub-Harness P/N 32190-MCA-305) in my 2001 GL1800. Ran into a couple items I thought it might be helpful for others to know if they're considering installing this harness. Fred has...