12 volt DC accessory socket kit

4190 Views 10 Replies 8 Participants Last post by Jetjocky, May 27, 2009

QC Goldwinger

Discussion Starter · Apr 28, 2009

I would like to install on my 1800 for charging cell and using GPS. As I understand from Hal's site, this accessory is placed within the front side pocket - either left or right. Supposed to be plug and play. Since I have Ram mount for left side - thinking about putting in left pocket. I also have the volt meter installed which is plugged into the accessory plug underneath the left front pocket.(on pre-2006 this accessory plug was under right side) Wondered if there is another available plug for connecting under left front pocket or would I need to obtain another wiring harness which would enable me to plug both the volt meter and accessory socket in this single connector.

Since I haven't seen one installed, wonder - do you just lay in bottom of glove box or is the plug actually mounted to the inside of the box? Any info or guidance would be appreciated.

Save

1 - 1 of 11 Posts

Timmer

· #9 · May 1, 2009

I put a 12v receptacle in both pockets. On the left side I built my own Y-connecter using molex connectors that I acquired from EC. Way cheaper than buying the $14.95 Y connector. The box on my '03 was marked for the hole.

On the right side I again made a custom wire harness that plugs into the heated grips power connector (I don't have heated grips) that buried down next to the airbox and above the vent. I also have a 12v receptacle in the trunk that works well.

For all of the connectors that I made, I hand crimped and soldered them. By building my own harnesses, I didn't cut into the factory wiring.

Save

1 - 1 of 11 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month