GL1800Riders Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
495 Posts
Discussion Starter #1
I need to readjust the torque on my new All-Balls bearings. I could buy the socket but I don't anticipate needing it after this adjustment.
 

·
Registered
Joined
·
1,084 Posts
ccsshafer, You CAN use a 1-3/16" SOCKET. " MAY" BE EASER TO

FIND.

1-3/16 = 30.15 MM.
 

·
Registered
Joined
·
1,084 Posts
csshafer, You can also make the nut wrench from a piece if 1-1/2"

pipe and 2 flat washers. + weldor + hacksaw + square file.
 

·
Registered
Joined
·
581 Posts
I believe a 1-13/16th socket is needed. I used a Cratfsman, 12 pt. Be careful because others are not deep enough to clear the stem.
 

·
Registered
Joined
·
128 Posts
Now I'm confused.... I was reading another thread and it said I could use a 1-11/16 socket ... I hope its true, cause I just ordered it! >I just recieved thr 1-11/16 socket....It fits !!!!!
 
1 - 6 of 6 Posts
Top