GL1800Riders Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
365 Posts
Discussion Starter #1
I have a bike lift I have used for years on the Harley, but now want to put the Honda Up on it.

Do I need to remove the Belly Pan? I was planning on using a couple of 3/8" pices of wood on the forward arm, but it will press on the belly pan.

Thanks again in advance, this board has been a wonder for a NEWBIE 1800 Owner. The Bike is less than 2 months old abd we have over 13,000 on it already. Going to chase the our Harley Miles, which is at 245,000.

Love the Honda and plan to sell the Harley, not that we do not like the Harley, just cannot ride more than one bike at a time and prefer the HONDA.
 

·
Registered
Joined
·
200 Posts
I have the Sears lift, and have used two other brands, no issues with
either and the belly pan. But then again, there is always a first time :)
 

·
Registered
Joined
·
28 Posts
I have a belly pan and use a Pit Bull lift without any problem. When I bought the lift the Pit Bull guy supplied an adapter for non belly pan Wings. He said not to use it if you have a belly pan, so you should be ok. Just put the rear lift point on the points sticking down from the folded up center stand and the front on the engine bottom. Lots of posts here on how to lift.
 
1 - 4 of 4 Posts
Top