GL1800Riders Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,926 Posts
Discussion Starter #1
I did a search on the forum for "flash to pass", but it deals mostly with garage door openers. Is there a way to wire the CB mic switch to flash the high beams? Thanks!
 

·
Registered
Joined
·
3,216 Posts
Is there a way to wire the CB mic switch to flash the high beams?
The PTT circuit pulls to ground at Black-wire Pin 9 of the CB connector, use this to trigger a relay (one with <100mA draw) with it's other end connected to the +12V. (2001-2005) One side of the relay contact to +12V, the other wire T'd into left high beam blue wire. The right high beam is itself independently relay-driven as a slave to the left high beam circuit.

Why? The difference between the two switches (PTT and high-beam) is 1.5".
 
1 - 2 of 2 Posts
Top