GL1800Riders Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1
I have a set of Cobras on my Wing and wanted to remove the baffles to see what it sounds like. I have read previous posts on the site of folks who had removed theirs just playing around and they were too loud for them, but I want to see how it sounds for myself.

So how do you get them out? They have been on the bike for a year now.
I understand after removing the two screws on the end, they just slide out. So where do you pull from or the trick to get them out.

Thanks the assistance! :D
 

·
Chard Member
Joined
·
12,960 Posts
Warning.... They will vibrate your eyeballs without the baffles! LOL....

Spray some WD40 around the back side of the baffle. Wedge something into the baffle/hole like a handle of a shovel then twist. I used a pipe expanding tool to get a bite and pull them out.

Just in case you're not real wrench savy, remove the two bolts in each baffle before you try to remove them. :idea:

This is for the slash cuts. I haven't removed them from the billet type yet.
 
1 - 2 of 2 Posts
Top