GL1800Riders Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
174 Posts
Discussion Starter #1
Hi,

Thinking of getting the Hondaline wind deflectors for the standard windshied. Do I have to drill holes to mount them??

If so has anyone done it and what was the success rate? Any cracks etc?

Thanks in advance.

FTW
 

·
Registered
Joined
·
67 Posts
Fly the wing. Yes you have to drill holes to mount them, I wanted a set myself but did not buy them because of that.
 

·
Registered
Joined
·
174 Posts
Discussion Starter #3
Elchino said:
Fly the wing. Yes you have to drill holes to mount them, I wanted a set myself but did not buy them because of that.
Thanks, then I think I too shall pass on them.

FTW
 

·
I U Turn
Joined
·
888 Posts
Fly ,I hade a set on for awhile .They did'nt help as far as more protection for the passenger goes. I don't think they are worth the money,and i won mine at a rally.
Mick :D :D
:yw1:
 

·
Registered
Joined
·
221 Posts
If you drill holes on plastic the drill bit should have a 60deg angle and use the highest speed possible up to 3000rpm

:yw1:
 

·
Registered
Joined
·
2,625 Posts
I would add to start very small and work your way up ? Be prepared
for the bit to grab and run though fast. Sooooo easy on the pressure!
 

·
Registered
Joined
·
221 Posts
If you drill holes on plastic the drill bit should have a 60deg angle and use the highest speed possible up to 3000rpm

:yw1:
 
1 - 7 of 7 Posts
Top