GL1800Riders Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
405 Posts
Discussion Starter #1
I was installing the EC panel and fuse block today on my '06. I stripped the head of the screw on the accessory terminal where the trigger wire should go. :oops: I'll try my Dremmel to cut a slot tomorrow. Any other ideas should that fail? Also, what is the screw directly under the accessory terminal for? The recommended alternate connection is to a relay wire. I dont see that relay on the cover, and I don't know where to find the correct wire for the power tap. Are the '06 relays different from previous years?
 

·
Banned
Joined
·
350 Posts
I installed a EC power panel on my 06. I seem to remember there were two screws one for power and one I believe was a ground. I cannot remember for certain.

I will says this; I am happy with the EC but I like the way it fits on a 1500 better than on the 1800. It makes the side cover a bit hard to fit on my 1800.
 
1 - 2 of 2 Posts
Top