GL1800Riders Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter #1
I'm currently changing out my air filter. During reassembing I'm at the stage where the cruise and ecm module's are bolted down, and I have a 13 terminal female connector laying from left to right in front of the fuel filler tray. The harness end's near the MAP sensor. I don't see the male side, or is there one?
I tried to see it on the Steve Saunder video in the How-To-Board ,but I don't see it there. Thought I would ask before I go back and remove the module's again to see if there is a connector misplaced below.

Thank's in advance
 

·
Registered
Joined
·
29 Posts
Discussion Starter #3
Thank's Hunzee I'm not sure this was loose when I disassembled. I could be for a CB since I don't use one.
 
1 - 3 of 3 Posts
Top