GL1800Riders Forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
548 Posts
Discussion Starter #1
On for a second or two then one more blink with a space the 5 more blinks what is it?

Sent from my SAMSUNG-SM-G891A using Tapatalk
 

·
GL1800 Doctor
Joined
·
20,366 Posts
On for a second or two then one more blink with a space the 5 more blinks what is it?

Sent from my SAMSUNG-SM-G891A using Tapatalk
If you wait, it should repeat. Sounds like a 25, right knock sensor or ECM. Any running symptoms?
 

·
Registered
Joined
·
548 Posts
Discussion Starter #3
Found it a wire was not connected

Sent from my SAMSUNG-SM-G891A using Tapatalk
 

·
Registered
Joined
·
548 Posts
Discussion Starter #5
Its a long story but long story short. We had removed the engine to fix the 5th gear and we are just getting it back together. I have another issue I will start another topic

Thanks


Sent from my iPad using Tapatalk
 

·
Vendor
Joined
·
17,784 Posts
Its a long story but long story short. We had removed the engine to fix the 5th gear and we are just getting it back together. I have another issue I will start another topic

Thanks


Sent from my iPad using Tapatalk
Boy that's a huge part of the story that was left out in the OP !!! Be sure to clear you DTC code.
 

·
Registered
Joined
·
548 Posts
Discussion Starter #7
How do you clear the codes?


Sent from my iPad using Tapatalk
 

·
Vendor
Joined
·
17,784 Posts
How do you clear the codes?


Sent from my iPad using Tapatalk
Assuming that you have a Service Manual > PGM-FI section > self diagnosis memory reset procedure. It probably on page 8.
 

·
Registered
Joined
·
994 Posts
How do you clear the codes?


Sent from my iPad using Tapatalk
1. Turn the ignition switch to “OFF.”
2. Short the service check connector terminals (3P
black connector with green and black leads) with
a jumper wire.
3. Turn the ignition switch to “ON.”
4. Remove the jumper wire from the service check
connector.
5. The MIL will light for approximately 5 seconds.
While the MIL lights, short the service check connector
terminals again with the jumper wire. The
self-diagnostic memory is erased if the malfunction
indicator goes off and starts blinking.
• The service check connector must be jumped
while the MIL lights. If not, the MIL will not start
blinking.
• Note that the self-diagnostic memory cannot be
erased if the ignition switch is turned “OFF”
before the MIL starts blinking.
If the MIL blinks 33 times, the self-diagnostic memory has not been erased.
 
1 - 9 of 9 Posts
Top