GL1800Riders Forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
626 Posts
Discussion Starter #1
Thought I had it book marked but can't find. Anyway what I'm looking for is the foam grip sleeve that will fit over the stock grips.

Thanks
Fox in GA
 

·
Registered
Joined
·
118 Posts
Use LOTS of soapy water, I need to remove the throttle grip and reinstall cause when I put the foam grip on it pushed the rubber grip up against the switch housing and will not snap back when you let off.
 

·
Registered
Joined
·
626 Posts
Discussion Starter #7
DoubleR, Thanks that's the one I remember.

Red, Thanks for the DS part number I will check that out tomorrow.

Johnnyva, Thanks for the install tip.
 

·
Registered
Joined
·
75 Posts
I have the Grip Tek and it works great with Honda heated grips.Also best way to install is to start the cover on,and then use air nozzle from outboard end.It will float right on.
 

·
Registered
Joined
·
8,253 Posts
Johnnyva said:
Use LOTS of soapy water, I need to remove the throttle grip and reinstall cause when I put the foam grip on it pushed the rubber grip up against the switch housing and will not snap back when you let off.
I just lubed it up with a little dish soap. No water at all. They slipped right on. No mess - nothing to wipe up.
 
1 - 9 of 9 Posts
Top