GL1800Riders Forums banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1,711 Posts
Discussion Starter #1
I wanted a vent, so it was easier / safer to buy a new windshield, so here's my old one. Listed on Facebook Marketplace too, so it might sell there?

It has 50K miles on it, so it's not perfectly clear, but it's very good. I tried to get the *worst* photo I could to represent it fairly. One photo is with light at an angle, and one photo is right through it.

It can ship in the original box and wrapping materials that the new one came in.

Asking $75.
 

Attachments

  • Like
Reactions: cycledude

·
Registered
Joined
·
2,440 Posts
I have cut the vent hole in several Honda windshields. Not a hard job with a drill, some tape to protect the surface and a hand keyhole-saw. It's much easier with an old one with the factory hole to use s a template. Just lay one over the other. Mark with a sharpie. Clean up the new hole with sandpaper or a hand file.


Just a thought or other possible option.:capwin:


Corventure Dave
 

·
Registered
Joined
·
1,711 Posts
Discussion Starter #3
Seeing as the new windshield and vent has been on the bike for six months, it's too late for that option! :)
 
  • Like
Reactions: cycledude
1 - 3 of 3 Posts
Status
Not open for further replies.
Top