Joined
·
5,109 Posts
For attachment points on a trailer floor I used these.
From the front to rear I used 48" because that's where the floor stringers were.
I drilled the front points through the stringers, placed the wheel chock, and found the rear points(stringers).
Of course all this depends on where the bike ends up over the axle.
A good rule of thumb is 60% of loaded trailer weight ahead of axle center.
From the front to rear I used 48" because that's where the floor stringers were.
I drilled the front points through the stringers, placed the wheel chock, and found the rear points(stringers).
Of course all this depends on where the bike ends up over the axle.
A good rule of thumb is 60% of loaded trailer weight ahead of axle center.
