GL1800Riders Forums banner
  • Hey everyone! Enter your ride HERE to be a part of August's Ride of the Month Challenge!
1 - 4 of 4 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
First time on the Tech Board. I'm new to the 1800, upgraded from a 86 Cavalcade, handelbars were 2" narrower and 1 1/2" lower bringing them closer. more relaxing. I find the 1800 handlebars quite wide and high, any way to adjust this?

PS. Been reading the tech board for months and find it the best on the net.
 

·
Chard Member
Joined
·
13,417 Posts
You can drill out the rear holes to 1/2" in the bar mounts. That will let the bars be turned in. If you want them even closer together you can drill the fronts out also.

I wanted just the opposite when I had the stock seat on the bike. I needed the bars farther away from me.

 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top