GL1800Riders Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
553 Posts
Discussion Starter #1
:?: 03 wing,i looked at h/direct and see the clutch & brake helmet hanger studs..it sure looks like the brake side would hit the master cyl..anyone have these and how is the fit and are they handy to have ? thanking you in advance
 

·
Registered
Joined
·
83 Posts
I have them on my 01 and they fit all 1800's. Don't use them much, tend to latch my helmet and then put it over the mirror.
 

·
Registered
Joined
·
9,099 Posts
I have them, use them all the time. No, they do not hit anything.
 

·
Registered
Joined
·
12,417 Posts
I had them on my 1500

But did not like them all that much. So I guess I can say that I don't care for them, but that don't make them bad.

Bulldog
 

·
Registered
Joined
·
9,099 Posts
Might make one comment on hanging the helmet over the mirror -
It works, and is handy, BUT

If you move the bike around with the helmet on the mirror (like
out of the garage, etc), and if the helmet is on the right mirror, the
brake lever will hit the helmet, and can initiate a tipover. So, I
quit using the mirror as a hatrack. Right after the second upset.

So I am a little slow. But it gets there.
 
1 - 7 of 7 Posts
Top