GL1800Riders Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
478 Posts
Discussion Starter #1
Am I looking at the wrong connection on my bike or did EC send an incomplete "Bike to Box" wire interface. What I recieved does not look like the picture on there web site.





I hope I'm wrong so I can go ahead and hook it up.
 

·
Vendor
Joined
·
21,428 Posts
Contact Lewis and let him know they removed the wrong connector. It should have a female end, not the male end. I'm sure he will get you fixed right up with a new cable. The male end was for a pass through connector that I believe they were going to remove. It looks like they may have taken off the wrong one on yours.

 

·
Registered
Joined
·
478 Posts
Discussion Starter #3
Got an email from Lewis and said they had a few that where sent out with the wrong cable. Will replace as soon as possible. Was hoping to have for this weekend. I was going to ride to Dallas if the weather didn't look too cold.
 

·
Registered
Joined
·
1,576 Posts
Talked with Todd @ EC this morning. 10 of the bad cables went out. They have found 8. They are hoping the new parts come in today or tomorrow and then they will turn around and ship them out.

I was going to ride to Dallas if the weather didn't look too cold.
BTW smc, high temp on Saturday here is suppose to be around 45...:-(
 
1 - 7 of 7 Posts
Top