GL1800Riders Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter #1
I'm installing MBL risers. Did the right side last night. Left to do tonight. Question: Do any of the wires or cables have to be released from the holder that keeps them running inside of the handlebar? On the right side there were specific instructions for this and 2 cable ties were included to tie them inplace. But nothing for the left side. Anybody know?

Thanks
 

·
Registered
Joined
·
634 Posts
:cool: As I watched the installation last Friday, I didn't see anything done to the wiring, etc on the left side. Only on the right side. Ensure when the handlebars are fully turned left and right that there is no interference. It actually took longer to cut and fit the black plastic cover than installing the risers. They are so sweet and eliminated any discomfort I had in the shoulder and upper back area. :yes1:
 

·
Registered
Joined
·
48 Posts
Discussion Starter #3
What I did was just pull the wires out a little bit from the loom down at the base. Your right though, I also like how they feel. I have the new "wide" version that maintain stock width. :thumbup:
 
1 - 3 of 3 Posts
Top