GL1800Riders Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
230 Posts
Discussion Starter #1
It has been brought to my attention that there is an error in the drawing I sent to a few of you showing my version of a cam tensioner tool.If you go to my homepage on Putfile you will see revised drawing.the error is on the lips on the bottom wheel.I should have put .377 instead of .077.This error is corrected on the homepage,Which is http://putfile.com/jimciampi
Sorry for the error and I hope this helps save some of you some money...Jim
 

·
Registered
Joined
·
1,244 Posts
Thanks Jim :!: That looks like a nice rainy day project. What did you make it out of? Aluminum? Steel? Plastic? I think the wheels could be modified slightly for use with a small square screwdriver.
 

·
Registered
Joined
·
5,936 Posts
Fred H. said:
I'll take one. How much are you selling them for?
Me too. I don't have the equipment to make one, but I have the money to buy one. If it's less than the Honda price, I'm ready.
 
1 - 5 of 5 Posts
Top