GL1800Riders Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
563 Posts
Discussion Starter #1
I've ordered the Hondaline heated grips for my 03 GL1800, does anyone know what size hole I need to cut in the fairing panel for the controller to fit?
 

·
Registered
Joined
·
79 Posts
goldwingrider.steve said:
I've ordered the Hondaline heated grips for my 03 GL1800, does anyone know what size hole I need to cut in the fairing panel for the controller to fit?
I just installed these a fews weeks back so it is still fresh in my mind. The directions called for a 45 mm hole. I used a 44mm (1 3/4") hole saw and it work fine.
 

·
Registered
Joined
·
33 Posts
hondaline heated grips

Did you guys have any problem with putting on the throttle grip? Did it get stuck half way on?

Thanks in advance,

Ralph
 

·
Registered
Joined
·
79 Posts
Re: hondaline heated grips

rlefter said:
Did you guys have any problem with putting on the throttle grip? Did it get stuck half way on?

Thanks in advance,

Ralph
Yes it did get stuck half way. After a minute of gentle persuasion (read gentle twisting) it went all the way on. One thing I did not do that the directions said to was take the throttle sleeve off the bike. I left it on and did the install with little to no problems. Just my 2 cents.
 
1 - 4 of 4 Posts
Top