GL1800Riders Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
755 Posts
Discussion Starter · #1 ·
I am trying to install the CJ Industries flashing brake light kit on my '06. I cannot figure out the routing of the wiring. I know I need to go light assy. to light assy, but how do you get the wiring under the flooring of the trunk and up the two tubes into the recess where the trunk tail lights attach?
Any help would be appreciated.

Thanks!
http://new.photos.yahoo.com/kg5ie/album ... 2384263907
 

·
Banned
Joined
·
7,603 Posts
I have this system! One of the poorest engineered items I've seen for the hookup.
You need to remove the lights to get at the bikes wiring. The units wiring is routed in the trunk not below the floor. I had to add some length to some of the wiring to get mine installed.
Then maybe my problem was I didn't follow the almost non-existant instructions correctly!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top