GL1800Riders Forums banner

1 - 5 of 5 Posts

·
Banned
Joined
·
1,855 Posts
Discussion Starter #1
I installed a new single left side Powerlet today. Although I know almost zero about wiring, I found the project quite simple to install probably, about one hour to do the job. I'll use it for Gerbing heated gear, charging and my small compressor.

The biggest disappointment was the cost, over $48.00 shipped from the factory. However, the day after ordering it, discovered the same exact Powerlet on Ebay for $39.00 with free shipping. I think they're still on Ebay, at least they were earlier today.
 

·
Registered
Joined
·
85 Posts
Where did you mount it

Just wondering where you mounted it for use with heated clothes?
 

·
Banned
Joined
·
1,855 Posts
Discussion Starter #3
Just wondering where you mounted it for use with heated clothes?
The left side is where I mounted the Powerlet for the heated gear. That is where I mounted the Powerlet on my ST, and it worked well.
 

·
Banned
Joined
·
1,855 Posts
Discussion Starter #5
1 - 5 of 5 Posts
Top