GL1800Riders Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
93 Posts
Discussion Starter #1
Well its been quite a day here at the Harris 'Otel'. I can read but I cannot understand Kennedy's instructions on the power harness installation. "Connect the GL1800 Power Harnes plug P2 to the bike's wiring harness". "It is located in a wiring bundle just under the left top vent". Where oh where is this bundle located (how do you get to the 'left top vent?)and what does is look like?

Inquiring fools need to know! As always thank you so much for your help!
 

·
Registered
Joined
·
6,891 Posts
You've got to pull the Left fairing pocket to get to the plugs - on the '06 you'll need to remove the trim strip first (start at the bottom and slowly work it side to side to release the tabs).

To get the pocket out, you'll need to depress the pin in the center of the rivets and then carefully lift the pocket out. Once you get it out, you'll need to look forward up under the foot vent controls for the black rubber boot. Inside it, you'll find the ACC power connector (Red) and the AUX audio connector (White).



Before replacing the rivets, you'll need to push the pin back up so that the pin extends above the top of the rivet body. Insert the rivet back in the hole and push the pin flush while holding the pocket in place.
 
1 - 2 of 2 Posts
Top