[V65_sabrr]

Mine quit modulating. Is there a way to reset them so they will modulate again. On my 2006 they quit once and I could reset them. Can it be done on the 2018?

 

[ADekock]

Check that your day-light sensor isn't obscuring your day light.

 

[reginaldmc]

I did not see anything in the manual about resetting. I would contact Kisan for support.

 

[Pooch]

Joe, I don't know about the 2018's but check the wire from the master to the slave, mine came loose.

 

[reginaldmc]

I noticed that mine was intermittently modulating. I finally disconnected and re-plugged it and pulled back on the plug. It started modulating again.

 

[ShanghaiDan]

Rapidly clicking your high beam switch on and off will change modes, and can cause - in my experience - the module to "go nuts". Unplugging and re-plugging works. Just be careful and don't toggle the high/low beam switch more than 3 times in ~5 seconds.

 

[V65_sabrr]

Contacted Kisangani. They said bad light sensor. They sent me a new one and now all is good.