Joined
·
23 Posts
ive seen the question asked, but never saw a definitive answer, so I figured Id give it a go..
mines an 02...
didnt see any big issues during a pre fit, so i decided to proceed
i trimed the outer ridge from the honda grip, then basically followed the directions...they were resistant to squeeze shut, but a large slip joint plier and a rag accomplished the goal of "shutting them"..not sure if that is unique to the older grip or "the nature of the beast" all of them
they are a larger diameter than the reg kury grips..wll have to see if that is an issue, but I knew that from previous posts
i guess the point is they apparently WILL fit the earlier wings, at least in my experience
mines an 02...
didnt see any big issues during a pre fit, so i decided to proceed
i trimed the outer ridge from the honda grip, then basically followed the directions...they were resistant to squeeze shut, but a large slip joint plier and a rag accomplished the goal of "shutting them"..not sure if that is unique to the older grip or "the nature of the beast" all of them
they are a larger diameter than the reg kury grips..wll have to see if that is an issue, but I knew that from previous posts
i guess the point is they apparently WILL fit the earlier wings, at least in my experience