GL1800Riders Forums banner

1 - 11 of 11 Posts

·
Registered
Joined
·
80 Posts
Discussion Starter #1
The "Honda" logos on the front/rear of the bike seem to be designed to snag rags and be a pain to clean. Any options other than going nekkid? :eek:4:
 

·
Registered
Joined
·
4,241 Posts
Blues Guy said:
The "Honda" logos on the front/rear of the bike seem to be designed to snag rags and be a pain to clean. Any options other than going nekkid? :eek:4:
You can use a recycled toothbrush for cleaning. Or, if you go nekkid, the front and rear badges can be removed by using dental floss carefully (no locating holes are used on the front and back).
 

·
Registered
Joined
·
4,823 Posts
Arn Butt Bill said:
[quote="Blues Guy":l2bbpawk]Any options other than going nekkid?
Here; these look like they're chrome...

[/quote:l2bbpawk]
Nipple rings!!!!!
(Nevermind, I said the quiet part loud again, damn this ADD)
 

·
Registered
Joined
·
9,099 Posts
There are only two - so I guess we know where to hang the D Q ...... :22yikes:
 

·
Registered
Joined
·
80 Posts
Discussion Starter #9
You would have to have 5 nipples to spell HONDA !! Laughing Laughing
_________________
Hedo
I had it figured out that with my wife accompanying me, we could at least spell "HOND" - then she informed me what would be pierced to add the "A."
I have since lost my enthusiasm.
I appreciate your thoughtful comments - think I'll just remove all of the logos and see if I can find one for the front that says "Powered by Guinness."
 

·
Registered
Joined
·
1,768 Posts
I bought an aftermarket trunk lid hand that just covers that rear "HONDA" just beautifully.
 
1 - 11 of 11 Posts
Top