GL1800Riders Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
906 Posts
Discussion Starter #1
I know that it has been posted before, but I can not find it. What kind, size etc. are the ones used on the wing, front and rear?

Joe in Redding
 

·
Registered
Joined
·
1,860 Posts
.463 hole diameter. Right angle is much easier to check pressure. Tho if Honda had drilled the hole in a better spot, one could use straight stems.
 

·
Registered
Joined
·
1,398 Posts
:agree: On the patchboy from Shinhopples. I just ordered 10 of them. I change out a few tires and keep them on hand. I might ad great deal on Dynabeads.
 

·
Registered
Joined
·
442 Posts
Actually you can use a short, straight, metal or rubber stem without any problems. My air chuck is a Milton which works on straight and 90 degree stems. I carry a small, Schrader, curved stem adapter to use if I get stuck someplace where the air chuck will not fit a vertical stem. First thing I did when changing to vertical was to be sure I didn't have a problem with ANY air chuck on the road like at 7-11's.
 
1 - 5 of 5 Posts
Top