GL1800Riders Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
70 Posts
Discussion Starter #1
Any help with who stocks the best selection of OEM parts. I have a new wing and when I went to put on the chrome side stand, I noticed the "special bolt" was cross threaded from the factory. Finally got it out but it is toast. I need the bolt and nut. Here are the part #'s. Will be in the Tampa area tomorrow, but other than that I need a source to get it overnighted. I have no stand now and need it by the weekend.

90108-MR5-000
90203-MF9-710
 

·
Registered
Joined
·
2,066 Posts
Since no one responded, I'd suggest checking a hardware store and take your bad bolt with you to find a match. That might hold you til you can get the correct "special" bolt and nut. Good luck
 

·
Registered
Joined
·
4,729 Posts
Ace or TrueValue would most likely have it. They carry metric nuts and bolts.
 

·
Registered
Joined
·
589 Posts
I believe it is a fine thread metric bolt, so take the old one with you as same for diameter and length and possible thread pitch.
 

·
Premium Member
Joined
·
12,496 Posts
Stop by my house..
I've got spare's.
... near Silver Springs.

Dennis.
 

·
Registered
Joined
·
70 Posts
Discussion Starter #7
Why it is special.....

The bolt in question is the large bolt that holds the stand on. It is tapped in the center to receive the smaller bolt that attaches the switch. Hardware store option won't work, need the Honda bolt & nut.
 
1 - 7 of 7 Posts
Top