GL1800Riders Forums banner
  • Hey everyone! Enter your ride HERE to be a part of September's Ride of the Month Challenge!
1 - 2 of 2 Posts

·
Registered
Joined
·
617 Posts
Discussion Starter · #1 ·
I have a spare OEM windshield vent that I want to install in the shield on my 03 bike.
Can anyone scan and e-mail me a copy of the template for cutting out the hole in the screen?
 

·
Registered
Joined
·
9,099 Posts
Cutout is 9 1/4 inches wide - not 8 1/4 as I have written down, and this is off a standard height OEM windscreen.

Grid paper is 1/8 inch squares, and I would move the cutout up the windscreen about a half an inch so the vent will open over the top of a radar detector

 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top