GL1800Riders Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
595 Posts
Discussion Starter #1
Any one know the size of the plastic push pins. The 2 that are on the bottom front cowl. I am talking about the plastic that is in front of the clutch bleeder and that canister thing
 

·
Vendor
Joined
·
17,785 Posts
The rivet required needs to fill a 8mm hole. Many of the aftermarket rivets are for a 5/16" hole which is smaller. If it helps, this is the Honda part number.

CLIP *NH1* (BLACK) 91549-MW0-790ZA
 

·
Registered
Joined
·
353 Posts
Any one know the size of the plastic push pins. The 2 that are on the bottom front cowl. I am talking about the plastic that is in front of the clutch bleeder and that canister thing
I can't give you the size, but here is the part number. They're not too expensive to order.
CLIP, PANEL FIXING *NH1* (BLACK)
91549-MW0-790ZA
 

Attachments

·
Registered
Joined
·
3,098 Posts
Actually 5/16" is nearly identical to 8mm. Either should fit fine.
 
1 - 6 of 6 Posts
Top