GL1800Riders Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
755 Posts
Discussion Starter #1
I purchased a second remote. Has anyone ever posted the programming procedure on the forum? Can I use the normal Honda programming sequence?

I did a search for "programming remote" on this site and got something like 180 pages of posts...have not fished through all of them yet.

Thanks,
 

·
Registered
Joined
·
200 Posts
Here ya go...

1. Turn the ignition switch on - between one and four seconds
and press the trunk "Pop-Up" button on the transmitter while
aiming the transmitter at the trunk. Between one and four seconds
turn the ignition switch off. Note: keep the timing between one and
four seconds, too fast or too slow will cause the control unit to
lose the stored codes.

2. Between one and four seconds, turn the ignition switch on. Between
one and four seconds, press the trunk " Pop-Up " button on the transmitter
while aiming the transmitter at the trunk. Between one and four seconds
turn the ignition switch off.

3. Between one and four seconds, turn the ignition switch on. Between one
and four seconds, press the trunk " Pop-Up " button on the original transmitter
while aiming the transmitter at the trunk. Between one and four seconds
turn the ignition switch off.

4. Between one and four seconds, turn the ignition switch on. Between one
and four seconds, press the trunk " Pop-Up " button on the original transmitter
while aiming the transmitter at the trunk. Leave the ignition switch on.

5. Within 15 seconds, aim the transmitter (up to three) whose codes you want
to store at the trunk and press the " Pop-Up " button once on each transmitter.

6. Between one and four seconds, turn the ignition switch off.
7. Confirm proper operation with the new code(s).
 

·
Registered
Joined
·
755 Posts
Discussion Starter #3
Just to make sure I have this right, 1 and 2 are with new transmitter, 3 and 4 are with original. Correct?

Thanks,
 

·
Chard Member
Joined
·
12,960 Posts
kg5ie said:
Just to make sure I have this right, 1 and 2 are with new transmitter, 3 and 4 are with original. Correct?

Thanks,
No! You use whichever remote you want to. When you get to the last step push & release the one you're using for programming then push the other. You can program up to 3 to work at a time.

You can't fiddle fart around when doing it. You only have so much time between steps. If you talk slow, think slow, or read slow, let someone else do it! LOL....
 

·
Registered
Joined
·
755 Posts
Discussion Starter #5
Update & Thanks

Worked like a champ! Thank you both for your posts and assistance. Less than $10 and I have a second remote. Got it off of eBay..Honda SR2000.

Thanks again,
 
1 - 5 of 5 Posts
Top