Joined
·
401 Posts
So I have an idea...
I installed the CB over the winter break and found an interesting issue. I have a manual bike but when the clutch is pulled in its almost impossible to reach the PTT switch. On the old bike it was easy, forefinger toggle, meaning to you transmit whilst stationary. Well seems the new bike stops that happening. So I have a idea to 3D print an extension to the ptt switch to allow the use during "clutch in" moments. I'm going to try to produce it for myself but wondered if anyone is interested in one?
I installed the CB over the winter break and found an interesting issue. I have a manual bike but when the clutch is pulled in its almost impossible to reach the PTT switch. On the old bike it was easy, forefinger toggle, meaning to you transmit whilst stationary. Well seems the new bike stops that happening. So I have a idea to 3D print an extension to the ptt switch to allow the use during "clutch in" moments. I'm going to try to produce it for myself but wondered if anyone is interested in one?
