GL1800Riders Forums banner

Rear Wheel Removal(lugs too tight)

5K views 36 replies 29 participants last post by  GL03 
An old plumbing trick that works well for frozen threads: Saturate lugs with PB Blaster (this stuff is great)then as strange as it may sound wait a half hour or so and try to tighten the lugs just a little then try to loosen them. This works 90% of the time on screws, bolts, pipes. good luck.
 
Dive Master said:
Teaser, PB is some fine stuff, best I have ever used.
Yep, I used it to break loose a VERY stubborn oxy sensor on an exhaust system once. Then used it free up a frozen bearing on an idler pulley, that stuff made it free wheel and spin smoothly, that was all it took to win me over.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top