GL1800Riders Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
113 Posts
Discussion Starter #1
Does anyone have the procedure to program a new remote? I have a new one and would like to get it set up.

thanks
 

·
Registered
Joined
·
4,214 Posts
I never could figure out the "aim the transmitter at the trunk" part. :D

To get back home do you hold your GPS upside down? LOL :a13:
 

·
Registered
Joined
·
1,902 Posts
Don't mean to repeat Wingman26 but here is a version you can cut-n-paste into a word document if you wish.

Whales,
"04 WHITE ABS"...............do you have your white 2004 already?


**********************
Transmitter Registration
GL1800
**********************


1. Turn the ignition switch on - between one and four seconds, press the trunk "Pop-Up" button on the transmitter while aiming the transmitter at the trunk. Between one and four seconds, turn the ignition switch off. Note: keep the timing between one and four seconds, too fast or too slow will cause the control unit to lose the stored codes.

2. Between one and four seconds, turn the ignition switch on. Between one and four seconds, press the trunk " Pop-Up " button on the transmitter while aiming the transmitter at the trunk. Between one and four seconds, turn the ignition switch off.

3. Between one and four seconds, turn the ignition switch on. Between one and four seconds, press the trunk " Pop-Up " button on the transmitter while aiming the transmitter at the trunk. Between one and four seconds, turn the ignition switch off.

4. Between one and four seconds, turn the ignition switch on. Between one and four seconds, press the trunk " Pop-Up " button on the transmitter while aiming the transmitter at the trunk. Leave the ignition switch on.

5. Within 15 seconds, aim the transmitter (up to three) whose codes you want to store at the trunk and press the " Pop-Up " button once on each transmitter.

6. Between one and four seconds, turn the ignition switch off.

7. Confirm proper operation with the new code(s).

NOTE:
[press the trunk " Pop-Up " button] means to press this button and hold it until the little light on the transmitter comes on.
 
1 - 5 of 5 Posts
Top