GL1800Riders Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
552 Posts
Discussion Starter · #1 ·
How do you remove the plastic light grey trim that goes arount the ingition switch, gauges and speakers? I haven't attempted to pull it off yet, I thought I would be a step ahead by asking. I did install a CB, speakers and other items when I purchased but that has been over a year ago. Thanks
 

·
Chard Member
Joined
·
13,488 Posts
chazzman said:
Sorry Red, 2005 Gl1800
Pop off both speaker grilles by applying pressure from the top. Remove one bolt and one push pin from each side speaker area. The panel is held in place with 4 rubber gromets, just pull the panel up and back a little to realease gromets. You have one plug to unplug in front of the key switch area. The clip on the plug has to be lifted toward the front of the bike with a small screwdriver so you can pull apart.

Good Luck.....
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top