[Dan18960]

I am amazed at the search skills of many on here - I would like to have just their little finger worth of that skill.

Recently there was a post referencing a plastic/rubber shield to cover the new Sena 50s mic so that it is protected from wind noise and more voice directed. They found it on Amazon and I can't find, remember, or get results from searching Amazon or this forum as to the accessory.

I do know that it was $15.00'ish. If you can link to that post or repost the Amazon part - THANKS!

 

[Jak]

I am amazed at the search skills of many on here - I would like to have just their little finger worth of that skill.

Recently there was a post referencing a plastic/rubber shield to cover the new Sena 50s mic so that it is protected from wind noise and more voice directed. They found it on Amazon and I can't find, remember, or get results from searching Amazon or this forum as to the accessory.

I do know that it was $15.00'ish. If you can link to that post or repost the Amazon part - THANKS!

Sierra Electronics carries them. I tried to give you the web link but the site is down at the moment.

 

[Navy Gator]

I know I guy who did this and it seemed to work well - Intercom Microphone Cover Stops Wind Noise - webBikeWorld

 

[Jak]

Sierra Electronics carries them. I tried to give you the web link but the site is down at the moment.

Here it is.

Sierra Electronics | L&T WINDSOCK DEFLECTOR WD20 - FITS CARDO, SENA, IMC, AND AIR RIDER SMALL WINDSOCK | WINDSOCKS | LT-WD20

Buy L&T WINDSOCK DEFLECTOR WD20 - FITS CARDO, SENA, IMC, AND AIR RIDER SMALL WINDSOCK from Sierra Electronics

www.sierra-mc.com

 

[Gnarly]

Ordered one, thanx.
Diane at Sierra says they will have more in stock by the upcoming Weds., including mine!

 

[Dan18960]

@Jak AWESOME! ! ! That is exactly what I was looking for. Thanks.

 

[DillTm]

I have one and I can not remember where I got it. But it is so simple to make. Find a plastic or vynl tube that will fit over the mic about 1inch to 1.5 inches. Then on one side cut a small oval out just big enough to let the mic slot be visible in the oval slot. Slide the original foam cover back over it. I save stuff and have a plastic cover that goes on a small 1/4 inch tube so that debris can not get into the tube. That is something that can be used for what you need. I have also seen those kinds of things that cover auto vacumn lines on Fords and Chevs

 

[FIRE UP]

There's also these:
156 Pieces Rubber End Caps Rubber Caps for Screws Rubber Caps for Bolts Rubber Screw Covers Bolt Caps Vinyl Caps Rubber Screw Caps in 9 Sizes from 2/25 to 4/5 Inch (Black): Amazon.com: Industrial & Scientific

While you'd get a bazillion pieces too much in the kit, you'd be able to find an exact fit over whatever size foam you'd use on your mic. And, it's a cheap kit. I use many of those for different applications on various vehicles and things around the house.
Scott

 

[Captron]

"Think'n" about order'n one of those caps my self..............What do you say Larry, should we "both" order an end cap..
Let me know and we can order together.....so we receive it at the same time...

Ronnie
7/9/23

 

[Gnarly]

Thanx,@Jak !
Just got notification from Sierra that they are back in stock; mine shipped today.

 

[Dan18960]

Ordered 3 for myself on July 9th. Shipped at 10:00 a.m. this morning. Expected delivery Thursday.