2006 gl 1800 43000 miles...did a 350 mile ride and got home trun off , then ,I need to move the bike so I turn on key and a funny bubbling sound came from the gas tank? bike came on and works ok. but turn it off and try to start it and bubbing sound? after the bike cool off the sound is gone? took the seat off and it was coming from the pump.
sounds from the gas tank?
1 - 5 of 5 Posts
Joined
·
3,082 Posts
http://208.43.95.107/forums/showthread.php?t=200652&highlight=fuel+pump+noise
Page down to the response from Pigeon roost.
Page down to the response from Pigeon roost.
Joined
·
4,935 Posts
It's normal
Joined
·
566 Posts
My wife says she hears sounds like that after I eat beans - go figure :wrong:
1 - 5 of 5 Posts
Join the discussion
Recommended Reading
-
Air filter change at 80K. Any help is appreciated
GL1800 Tech BoardChanged the air filter at 80K and wow did this need done long ago. This is what the air box looked like. Water and oil . The T fitting from the two tubes coming from the bottom of the air box. This drains into the top of the engine case. . I am in need of an explanation as to where all this...- 8
- 1K
-
Removing airbag on a 2015 GL1800 to get at Air Filter
GL1800 Tech BoardHi. I cannot find any online videos that show how to remove it to get at the air filter. I have a copy of Fred's videos but cannot find them after a house move. I also have a Honda workshop manual but can't seem to locate the section that talks about removal of the airbag to get at the filter...- 10
- 244
-
Valve Check
GL1800 Tech BoardThis post is asking what people think about the need to loosen the cam chain or leave it alone during valve clearance checks. I know this subject has been discussed but I was thinking of looking at it a bit differently that I am not sure anyone has talked about. Yes, some people say you need...- 6
- 139
-
DillTm · updated
-
CB radio question
GL1800 Tech BoardI have been looking at used CB radios on eBay to install in my 2004 GL1800 trike. Some say they come with filters and some say they do not come with filters. I’m not sure I understand what these filters are, I thought the cb just plugged into a wiring harness already in place under the seat plus...- 4
- 103
-
F6B: Sticking Brakes
GL1800 Tech BoardAfter installing Progressive Monotubes in my 2013 F6B over the winter I decide to get the bike out today and test. I only rode 1/4 mile and after hitting the brakes could tell there was a problem. The front left and rear calipers seem to stay engaged after applying either front or rear brake...- 0
- 46
Join now to ask and comment!