GL1800Riders Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter #1
I finally got around to installing my all balls bearings, the install went pretty good, torqued them to 22 pounds, and went for a test ride, no wobble at all ( had a terrible wobble before) but the steering feels a little tight. I'm just wondering if its because my other bearings were so loose ( I could loosen the adjustment nut with my fingers ) that I just have to get used to them. Or should I recheck the torque? Thanks in advance for any suggestions.
 

·
Registered
Joined
·
408 Posts
They will seat-in and loosen a little. Give them a 1000 miles or so and you'll be happy.
 
1 - 3 of 3 Posts
Top