GL1800Riders Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
675 Posts
Discussion Starter · #1 ·
I have seen this some place before and I decided to try this on my bike . I took some LED lights that I had left over from making my own muth mirrors. I took off my left speaker housing and drilled 4 holes 1/2 inches apart then I soldiered 4 leds and a resistor inline and I put the led's in the holes and hot glued them in and then I put silicone adhesive over the hot glue to make it water proof .
 

·
Registered
Joined
·
675 Posts
Discussion Starter · #5 ·
Yes they just work with the turn signals . I taped into the wiring harness under the trunk where a person would hook up a wiring harness for a trailer. I soldiered all of my connections and used shrink tubes to make a water tight seal. When you stand at the back of the bike you can see the lights and if you walk to the front of the bike you can see it flashing from all directions . I am hoping that this will add more awareness to others drivers when I am riding
 
1 - 3 of 3 Posts
Top