GL1800Riders Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
89 Posts
Discussion Starter #1
I'm on the home stretch from putting in Progressive Monotubes, All Balls bearings, air filter, Progressive rear shock spring replacement! However, I can't find (yet) where to plug in the connector in the attached picture. I took a picture before a picture of the inside after removing the shelter and it seems the wire/connector was going up the right side of the ignition, but I don't see any place to plug it into under the GPS screen. I fired up the bike and everything seems to be operating normally. Perhaps the connector is for a non-GPS display?

Dan bike wire2.jpg
 

·
Registered
Joined
·
288 Posts
I think it's the CB connector
 

·
Registered
Joined
·
3,809 Posts
Vic is correct that is for a CB plug in
 

·
Registered
Joined
·
427 Posts
Looks like the combination meter plug that goes on the front side(toward front of bike) of the ignition switch up under the meter panel cover after it is installed. The CB plug on my 07 is white in color.

Combination Meter Plug



CB Plug



But I could be wrong, it wouldn't be the first time just ask the wife :roll:
 
1 - 6 of 6 Posts
Top